4 Foot BetterWelds GSS – FBS4 Fitting

$85.00

Has “B” Screw-in Fittings on Welder end and Splice Fitting on Cylinder Regulator End

Description

Has “B” Screw-in Fittings on Welder End and Splice Fitting on Cylinder Regulator End That Model Fit Many US Made Welders and Most Non US Made Cylinder Regulators.

A Splice Fitting, has a hose barb on that hose end. It fits any welder and is simply spliced into a section of existing hose by cutting the existing hose about two inches from the existing fitting.

“B” Fittings for inert gas fittings are of a unique metal to metal seat design using a two piece design with straight NOT pipe threads. An excellent gas seal is made by tightening the matting brass surfaces. Don’t Use Teflon Tape.

CAUTION Some Cylinder Regulator-Flow Controls have similar looking thread fitting as two piece “B” like some Hobart and Miller 211 MIG welders and some made over-seas! Those threads look similar but are tapered pipe fittings, NOT straight threads like “B” fittings. The hose barb and threads are one piece NOT two. A SPLICE FIT-TING MUST BE USED IF THIS TYPE OF FITTING IS FOUND ON YOUR REGULATOR. NOTE: You are always safe ordering Splice Fittings on both ends as these will work with any existing hoses!

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.